Vehicle mold is the common result of a vehicle that has been exposed to an area with high humidity. This is most commonly found in places like garages, storage facilities, and warehouses. The good news is vehicle mold can be removed easily if you know what you are doing, or you can call the professionals at Mold Removal Louisville KY. Before you start, however, it is important to gather all the information you need to make sure you are prepared and complete the vehicle mold removal process.
First, be sure that there are no leaks in the area where the mold is present. If so, you will want to double-check the vehicle’s air conditioning system to ensure it is not leaking. You should also check the area’s temperature and ensure that it does not have a temperature above eighty degrees at any time.
When it comes to vehicle mold removal, it is crucial to determine the extent of mold growth. More severe areas will take more time to clean properly. It would be best if you start by removing the affected vehicle from the affected area. Please clean up the mold by scraping it away with a putty knife. Then, use a piece of glass cleaner to completely wipe off the mold in the affected areas, taking care to sand the edges of the glass gently.
Next, apply a mixture of two tablespoons of white vinegar and five tablespoons of borax to the affected areas. Allow the solution to sit for a full twenty minutes. After the time is up, remove the cleaner from the area and scrub away the remaining mold. Make sure to do this in a back and forth motion to ensure as little dust is produced as possible.
Once the area has been cleaned, make sure you rinse it down thoroughly. For additional protection, apply a plastic bag to keep the area dry. Before applying the next coat of sealant, check to make sure that it has dried thoroughly. When applying the first coat, make sure the area has dried thoroughly between the coats.
The area where the mold has affected your vehicle should be treated differently than the rest of the vehicle. First, make sure that all windows and any other area the mold has affected are covered with a plastic sheet. This will help to prevent further damage from occurring. It will also help to prevent the further spread of the mold to other areas of the vehicle.
As soon as the area has been treated, you should begin removing the damaged area. Take your can of automotive paint spray down the affected area one time with a large coating of automotive paint. Once the area has dried, use an air compressor to fill the can with paint and allow it to sit for at least four hours. After the time has passed, take a roll of carpet and roll it up very tightly. It would be best if you then taped the roll under the vehicle. Do not leave the tape on the window because you will have a wet line when you spray the next coat of paint onto the carpet.
For vehicle mold removal, you may also choose to purchase a hot water extraction system. This system is quite useful for people who are not comfortable using chemicals or do not want to deal with the clean-up process. The system consists of a tank of warm water with a rotary brush attached to a high-pressure hose. The brushes work to take the affected area and push out the contaminated water into a collection container. Chemical cleaners are also available for this process.